Lamp Information - Hapro Luxura X5 Manual

Lamp information

The lamps listed below are those that are installed as standard equipment at the factory. These standard lamps have been selected for
optimal tanning results and to match the UV classi cation of your tanning unit. We recommend that when you replace a lamp you only
use lamps of the type currently installed in your tanning unit and which are listed in the table below and on the identi cation plate. If you
choose to install a di erent type of lamp, you must only use lamps that are marked with an equivalent code which indicates that the UV
component falls within the equivalence range listed on the identi cation plate.
Note: The equivalent code is only applicable to low-pressure uorescent lamps.
Lamps
maxlight 25W CE III
maxlight 100W-R CE III
maxlight 100W-R CE 0,3
maxlight 100W-R High Intensive
maxlight XL 120 W-R CE III
maxlight XL 120 W-R High Intensive
maxlight 160W-R CE III
maxlight 160W-R CE 0,3
maxlight 160W-R High Intensive
maxlight XL 180W-R CE III
maxlight XL 180W-R CE 0,3
maxlight XL 180W-R High Intensive
maxlight HP 400W D
Lamps (IP-control)
maxlight 80-180W-R IPcontrol CE/N III
maxlight XL 80-180W-R IPcontrol CE/N III
Power facial tanner
300W
400W
300W
400W
300W
400W
Note: The total erythema is limited to 0.3 W/m² for all UV types within the EU.
Model : XXXXX
Type : XXXXXXXX
Serial number : XXXXXXXXXX / 3
Rated voltage : XXXXXXXX
Rated power input : XXX W
With Airco : XXX W
30 x maxlight 160W-R CE III
160-R-(21-28)/(2,2-3)
22 x maxlight XL180W-R CE III
180-R-(21-28)/(2-2,6)
22 x maxlight HP 500W S or maxlight HP 500W D
Main Filter: SPS (Art. nr. 15691) Ballast: 320W
UV type 3 (Total Erythema output limited at 0,3W/m
Manufactured by: Hapro International B.V.
PO Box 73
4420 AC Kapelle, Netherlands
Art nr equivalent code
23023 30-O-(2-3)/(42,5-57,5)
12797 100-R-(17-22)/(2,1-2,9)
16997 100-R-(20-27)/(2,3-3,1)
12801 100-R-(38-50)/(5,1-6,9)
12810 120-R-(27-36)/(2,8-3,8)
15898 120-R-(68-90)/(7,9-10,7)
12814 160-R-(21-28)/(2,2-3)
17001 160-R-(20-27)/(1,5-2,1)
15899 160-R-(77-102)/(6,9-9,3)
12818 180-R-(21-28)/(2-2,6)
17002 180-R-(24-32)/(1,7-2,3)
12821 180-R-(86-114)/(6,7-9,1)
12526 not applicable
Art nr equivalent code
19446 180-R-(37-49)/(3,4-4,6)
19447 180-R-(38-50)/(3-4)
Glass lter
HPS
HPS
SPS
SPS
BPS
BPS
Example:
On the example identi cation plate shown below the equivalent codes for the installed canopy and bench
lamps are circled.
The equivalent code for the canopy is 160-R-(21-28)/(2.2-3)
160 = the wattage of the lamp
R = the re ector type
(21-28) = the equivalence range for the total e ective erythema
(2.2-3) = the equivalence range for the NMSC ratio
If you intend to install a new lamp, the wattage and re ector type must always match the equivalent code
on the identi cation plate. The e ective erythema and NMSC ratio must also match the speci ed range.
You may only use a lamp other than the recommended type if all of these criteria are met. You must also be
aware that:
3 )
a. The tanning unit is likely to be less e ective in terms of tanning performance.
b. The circuit protection for your tanning unit must be adapted because the electrical current
consumption will have changed.
c. The UV classi cation no longer matches the original classi cation shown on the identi cation plate.
d. We will not necessarily honour warranty claims arising from the use of lamps other than those we
recommend, because the technical operation of your tanning unit might be a ected.
UV type (EU countries)
3
3
2
may not be used
3
may not be used
3
2
may not be used
3
2
may not be used
not applicable
UV type (EU countries)
not applicable
not applicable
UV type (EU countries)
2
may not be used
3
2
3
3
UV type (non-EU countries)
3
3
3
5
3
5
3
3
5
3
3
5
not applicable
UV type (non-EU countries)
not applicable
not applicable
UV type (non-EU countries)
2
2
2
2
3
3
5