Install The Hood; Install The Blower - Best WPD29M Serie Instrucciones De Instalación

9. INSTALL THE TRANSITION
Attach the provided transition to top of hood. Use metal foil duct tape to make all
joints secure and air tight.
10. INSTALL THE DECORATIVE FLUE (OPTIONAL)
O D
PTIONAL ECORATIVE
Refer to the instructions included with the optional decorative flue.
If this decorative flue is installed in a salt water area (example: coast), rinse all surfaces once a week with
clear water (even if the hood is not used), and wipe dry completely.

11. INSTALL THE HOOD

Rest the top back cavity of the hood on the wood mounting strip.
Hold the hood until it is completely secured to the wood
mounting strip.
Attach transition to 10" round duct. Secure the hood to wood mounting strip using
5 no. 10 x 2" hex head screws (included). Drill two 3/16" diameter holes into the
drywall for wall anchors through the existing holes in the inside hood back in the
locations shown. Then, install both wall anchors with no. 8 x 5/8" screws and
washers provided.

12. INSTALL THE BLOWER

Assemble barrel nut (packed with blower) approximately halfway onto threaded
stud on top inside of hood.
Lift blower inside of hood. Slide blower back to engage blower tab with slot in
hood top and slot in blower with barrel nut.
Use a long, flat-blade screwdriver to tighten the barrel nut securely. Plug motor
into receptacle, on exterior side of wire box.
F AEWPD S
LUE ERIES
CAUTION
(INTERIOR BLOWER ONLY)
HD0057
CAUTION
HD0061
HD0054
- 8 -
T (
OP OF HOOD INSIDE VIEW
M
OUNTING SCREWS LOCATION
B (
ACK OF HOOD INSIDE VIEW
W
ALL ANCHORS LOCATION
HD0184
B
ARREL NUT ON
THREADED STUD
D
ISCHARGE
OPENING
B
LOWER MOTOR
F -
LAT BLADE
SCREWDRIVER
)
)
S
LOT IN TOP
OF HOOD
D
ISCHARGE
OPENING
B
ARREL NUT