Prepare The Installation - Best WPD29M Serie Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. PREPARE THE INSTALLATION

When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses
and gloves.
Remove the installation kit from inside the hood.
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
Make sure that the following items are included:
- Wood strip (screwed on back of hood)
- Installation manual
- Transition (9'' x 18'' to 10'' round)
- Accessories including:
• 3 Baffle filters
• Shielded halogen lights (GU10 type base, 120 V, 50 W) (4 for a 42" width hood, 6 for a 54" width hood)
• Bag of parts including: 3 waterproof wire connectors, 5 no. 10 x 2" hex head screws, 2 wire clamps LP16-AP,
4 no. 10 x 2" flat head screws, 2 wall anchors, 2 no. 8 x 5/8" screws, 2 washers 3/16" ID x 3/4" OD.
Included in parts bag, but not to be used (please discard): 4 washers 3/16" ID x 3/4" OD, 1 no. 10 x 2" hex head screw,
4 stainless steel 10-32 locknuts, 2 no. 8 x 3/8" zinc-plated screws, 8 no. 8 x 3/8" stainless steel screws.
Parts sold separately:
- Interior blower Model P12D.
- In-line blower assembly ILB11, including transitions and rough-in plate. Discard the rough-in plate.
- Exterior blower assembly EB12 or EB15 (all include rough-in plate). Discard the rough-in plate.
- Duct, elbows, dampers, wall and roof caps. Refer to page 3 for a complete list of venting options and model numbers.
- Optional decorative flue AEWPD Series.
3. REMOVE THE FILTERS AND THE GREASE DRIP RAIL
A. Remove tape on filters.
Remove filters from hood and set aside.
NOTE: It is recommended to start with the
central one.
B. Remove tape on grease drip rail (1).
Lift out grease drip rail and set aside.
NOTE: When hood is in the position shown at
right and tape is removed from drip rail, it
could possibly fall out due to gravity.
4. REMOVE THE PAN
Using a Phillips no. 2 screwdriver, remove the screws retaining the pan (shaded
part on illustration at right) to the hood. Remove the pan and set aside.
WARNING
!
HD0182
- 5 -
1
R
ETAINING SCREWS LOCATION
HD0183

Publicidad

Tabla de contenido
loading

Tabla de contenido