SPORTSTECH F48 Manual De Instrucciones página 70

3. Adjust speed to l6KM/H after adjusting running belt to the middle, and observe deviation of running
belt and smoothness of running. Repeat steps of adjustment in case of deviation.
4. Warning! Please don't tighten the roller excessively! This will cause permanent damage to the
bearing!
You need to tighten the running belt again if the above steps fail to reach the effect.
Lubricating oil
The treadmill is oiled when leaving the factory, but lubricity of treadmill shall be inspected frequently,
which helps to keep it in optimum state. The treadmill must be oiled after 1 year or running for 100h.
Lift one side of the running belt and touch the surface of running platform after running for 30h or 30
days. It is unnecessary to lubricate if there is silicone oil. If the surface is clearly dry, please oil it as
instructed below.
Please use non-petroleum silicone oil
How to oil the treadmill:
1. As shown in the figure, it needs to oil the running belt after the treadmill is used for some time. Lift
one side of the running belt, place the silicone oil bottle below the running belt and apply silicone oil to
running board. (Apply silicone oil to the middle of running board).
2. Turn on the treadmill to run for some time after oiling to uniformly apply silicone oil to running belt.
Note: stop the treadmill to make the running belt still when oiling the running belt. Lower surface in the
middle of running belt.
Cleaning
Frequently clean the treadmill to guarantee its service life.
1. Warning: cut off the power when cleaning the treadmill. The power line must be pulled out from
the socket.
2. After use clear sweat stains and sundries on instrument and other parts with clean towel and damp
cloth.
3. Note: don't use corrosive articles and liquid to prevent damage to electronic elements. Don't expose
electronic elements to sunlight.
4. Every week clean the ground every week, and clear dirt brought by shoes and other sundries on
the ground.
Storage
please place your treadmill in clean and dry environment, and ensure that power switch is off and plug
is not in power socket.
Movement and folding
Handling wheel is added in design to move the treadmill. Please confirm that power is off and the body
of treadmill is folded before moving.
71