Product Information - Graco Turn2Me Manual Del Usuario

be purchased when any of the
aforementioned conditions occurs.
NEVER install this child restraint on
any vehicle seat equipped with safety
airbags when used in rear facing
mode.
NEVER use a second-hand child
restraint or a child restraint whose
history you do not know because
they may have structural damage
that endangers your child's safety.
Please keep this child restraint away
from sunlight﹐ otherwise it may be
too hot for the child's skin.
DO NOT use this child restraint as a
regular chair as it tends to fall down
and could injure the child.
DO NOT use this child restraint
without the soft goods.
The soft goods should not be
replaced with any besides the ones
recommended by the manufacturer﹐
because the soft goods constitute
an integral part of the child restraint
performance.
DO NOT put anything other than
the recommended soft goods in this
child restraint.
DO NOT put unsecured items in the
vehicle because they can be thrown
around and may injure occupants in
a sharp turn﹐ sudden stop﹐ or collision.
Do not place other items on top of
the child restraint if it is in the car
boot to prevent damage.
Do not allow the child restraint
harness or buckles to become
trapped or caught in the vehicle seat
or door.
DO NOT continue to use this child
restraint after it has suffered any
violent crash. Replace immediately
as there may be invisible structural
damage from the crash.
Remove this child restraint from the
vehicle seat when it is not in use for a
long period of time.
To avoid suffocation﹐ remove plastic
bag and packaging materials before
using this product. The plastic bag
and packaging materials should
then be kept away from babies and
children.
Consult the retailer for issues
concerning maintenance﹐ repair and
part replacement.
Do not place any objects in the load
leg area in front of your base.
DO NOT carry this child restraint with
a child in it.
Frequently check the ISOFIX guides
for dirt and clean them if necessary.
Reliability can be effected by ingress
of dirt﹐ dust﹐ food particles etc.
DO NOT use any load bearing
contact points other than those
described in the instructions and
marked on the child restraint.
12
Correct Installation is only permitted
by use of the ISOFIX connectors.
DO NOT install this child restraint
under the following conditions:
1. Vehicle seats with lap belt or
3-point-belt.
2. Vehicle seats facing sideways
or rearward with respect to the
running direction of the vehicle.
3. Vehicle seats movable during
installation.
Product
Information
1.
According to the UN ECE R44.04
Regulation﹐ the child restraint
is a Semi-Universal ISOFIX Class
A﹐C﹐D Child Restraint.
2.
If in doubt﹐ please consult the
child restraint manufacturer or
the retailer.
For Installation with ISOFIX System
This is an ISOFIX CHILD RESTRAINT
SYSTEM. It is approved to UN
ECE regulation 44﹐ 04 series of
amendments for general use
in vehicles fitted with ISOFIX
anchorages systems.
It will fit vehicles with positions
approved as ISOFIX positions (as
detailed in the vehicle handbook)﹐
depending on the category of the
child restraint and of the fixture. If in
doubt﹐ consult either the infant child
restraint manufacturer or vehicle
manufacturer.
The ISOFIX size class for which this
device is intended is A﹐C﹐D.
Suitable for Child weighing under
18kg
Mass Group Group 0+/1
Materials Plastics﹐ metal﹐ fabrics
Patent No. Patents pending
Concerns on
Installation
1 3
See images -
1
DO NOT install this child
restraint on vehicle seats that
face sideways or rearward with
respect to the moving direction
of the vehicle.
It is recommended to install this
child restraint on the rear vehicle
seat.
DO NOT install this child restraint
on vehicle seats movable during
installation.
2
DO NOT place rear-facing
child restraint on front seat
with air bag﹐ because death or
serious injury may occur. Please
reference vehicle owner' s
manual for more information.
13