Kohler K-3597 Manual Del Usuario página 4

Wax Seal
Bottom of Bowl
T-Bolt
2. Install the New Toilet
CAUTION: Risk of trap seal loss in back-to-back
installations. To prevent a trap seal loss, back-to-back toilet
installations must be connected to a vertical stack using one
of the following three fittings: double fixture, double
combination wye and 1/8 bends, or double wye and 1/8
bends.
Install or relocate the supply and outlet as necessary to conform
to the roughing-in dimensions.
Install a supply shut-off valve.
Lay the toilet down onto a padded surface.
From the bottom of the toilet, firmly press a new wax seal around
the toilet outlet.
Remove the temporary rag (if used) from the toilet flange hole.
Align and lower the toilet over the flange and T-bolts.
IMPORTANT! Do not lift or rock the bowl after placement. If you
break the watertight seal, you must install a new wax seal.
Apply your full body weight around the toilet to set the seal.
Place the bolt cap bases over the T-bolts in the "up" position as
marked.
Place the washers and nuts on the bolt cap bases and T-bolts.
Carefully tighten the nuts.
1086530-2-A
Bolt Cap
Bolt Cap Base
T-Bolt
Closet Flange
4
Nut
Washer
Kohler Co.