Operation - Omcan HP-CN-0035 Manual De Instrucciones

Installation
RUNNER REMOVAL PROCEDURE
1. Grasp the runner.
2. Tilt the runner up slowly while pulling the runner outward away from the side of the cabinet. Do not force it,
assure both sides are in the same position as you are lifting the runner.
3. Keep tilting until the runner touches the slotted side of the cabinet and with both ends of the runner are
equal distant from the cabinet side the runner will slide out easily. Do not force it.
ELECTRICAL CONTROLLER INSTALLATION
1. Remove the electrical control box from the packaging material.
2. Insert the electrical cord through the hole at the bottom of the cabinet.
3. Slide the electrical control box into the bottom slot of the cabinet.

Operation

1. Push main power switch (ON/ OFF rocker) to "ON" position.
2. Push HEAT/ PROOF switch to HEAT for heating ONLY.
3. Turn HEAT thermostat knob fully clockwise for preheat.
4. Allow 45 minutes for pre-heating, then turn thermostat to desired setting.
5. Place water in the "water pan" filling to about 3/4 full, for proofing.
6. For proofing, push HEAT/ PROOF switch to PROOF.
7. Adjust the heat and humidity thermostat knob to control desired temperature and humidity. Allow 45
minutes for pre-heating.
NOTE: The internal air circulation blower and 900W heater element (controlled with the "Heat"
Thermostat) will operate continuously when the power switch is turned "ON".
HEAT THERMOSTAT
The controlling range is 80°F to 185°F. The dial has numbers 1 thru 9 that do not relate to a specific calibrated
temperature. Temperature settings must be obtained through familiarization with the unit. The dial also has an
"OFF" position to turn heater unit off.
1 2
6
3