Replacing Belt; Replacing Agitator; Agitator Assembly - Panasonic MC-V5485 Instrucciones De Operación

Carpet/Bare Floor
Selector Shaft
Sélecteur tapis/plancher
Selector alfombra-piso
Motor Shaft
Arbre d'entraînement
du moteur
Eje del motor
End Cap
Bouchon
Tapa de
extremo
Groove
Ouverture
Ranura
End Cap

Replacing Belt

Belt Pulley
Courroie Poulie
Correa Polea

Replacing Agitator

Card
Carte
Tarjeta

Agitator Assembly

Remove lower plate and agitator.
Remove worn or broken belt.
Loop new belt (Panasonic Type UB8
only) around motor shaft and pulley
as shown.
Reinstall agitator back into nozzle
housing grooves.
After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Reinstall lower plate.
When the bristles on the agitator are
worn so that they do not touch a card
held across the lower plate, the
agitator should be replaced.
Remove lower plate and agitator.
Position belt over belt pulley on the
new agitator.
Reinstall agitator and lower plate.
Agitator Unit
- 40 -
End Cap