Troubleshooting - Silverline 806145 Manual De Instrucciones

GB

Troubleshooting

Problem Possible cause Solution
No power Check power supply
No function when ON/OFF
Switch (5) is operated
Defective ON/OFF Switch Have the ON/OFF Switch replaced by an authorised Silverline service centre
Sanding sleeve or Flap Wheel grit too fine or worn Fit new Sanding Sleeve or Flap Wheel with coarser grit
Slow material removal
Variable Speed Dial (4) set at too low speed Increase speed
Scratches on workpiece after Fit new Sanding Sleeve or Flap Wheel with finer grit and continue sanding
Grit too coarse
sanding of surface to remove scratches
Sanding Sleeve (19) or Detail Flap Wheel (20)
Fit correct Sanding Sleeve or Flap Wheel
incompatible with material
Burn marks on workpiece
Too much pressure exerted Use less pressure whilst sanding
Variable Speed Dial set at too high a speed Decrease speed
Sanding Sleeve incorrect size or faulty Replace with the correct size Sanding Sleeve
Sanding Sleeve slides off the
Sanding Sleeve Drum (18)
Oil or grease or other lubricant on surface of Sanding
Completely clean and dry the Sanding Sleeve Drum
Sleeve Drum
10