Troubleshooting - Silverline 247820 Manual De Instrucciones

GB

Troubleshooting

Problem Possible cause Solution
No power Check power supply
No function when On/Off
Rocker Switch (2) is operated
Have the On/Off Rocker Switch replaced by an authorised Silverline
Defective On/Off Rocker Switch
service centre
Slow material removal Sanding belt too fine or worn Fit new sanding belt with coarser grit
Sanding belt too coarse Fit new sanding belt with finer grit
Scratches on workpiece after
sanding
Not enough material removed Continue sanding
Sanding belt incompatible with material Fit correct sanding belt
Burn marks on workpiece
Too much pressure exerted on to the File Arm (8) Use less pressure whilst moving the machine
Belt not installed correctly Follow instructions in 'Fitting a sanding belt'
Belt slides off the File Arm (8)
when turning
Worn or defective sanding belt; belt with wrong
Fit a new sanding belt
dimensions
8