Remote Sensor; Sensor Data Transmission; Clock; Clock Reception - Oregon Scientific BAR206S Manual De Usuario

REMOTE SENSOR

The main unit can collect data from up to 3 sensors.
To set up the sensor:
1. Open the battery compartment (see FIG 3).
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 1.5 m (5 ft) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
1. 5 m ( 5 f t )
Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures below
freezing.

SENSOR DATA TRANSMISSION

To search for a sensor:
+ MODE.
Press and hold
The sensor reception icon in the remote sensor area
shows the status:
ICON
TIP The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.

CLOCk

CLOCk RECEPTION

This product is designed to synchronize its clock
automatically with a clock signal.
BAR206S:
Slide EU / Uk to select the signal received.
• EU: DCF-77 signal: within 1500 km (932 miles) of
Frankfurt, Germany.
• UK: MSF-60 signal: within 1500 km (932 miles) of
Anthorn, England.
4
DESCRIPTION
Main unit is searching for
sensor(s).
A channel has been found.
The sensor cannot be found.