Maintenance And Storage; Cleaning The Transducer - Lanaform Aroma Manual De Instrucciones

MAINTENANCE AND STORAGE:

EN
If the water contains too much calcium and too much magnesium it can leave a "white powder" in the
device. If this scum is deposited on the transducer (metal disk producing the ultrasound), the Aroma will be
prevented from operating properly.
We recommend:
1) Using boiled and cooled water or distilled water each time you use the diffuser.
2) Cleaning the reservoir every 2 days and cleaning the transducer each week.
3) Changing the water in the reservoir regularly. Don't leave it there for more than 2 days.
4) Cleaning the whole Aroma (see the explanation below) and making sure that all the parts are completely
dry when it is not being used.

Cleaning the transducer:

1) Place 2 to 5 drops of vinegar on the surface and leave for from 2 to 5 minutes.
2) Brush the scum off the surface using a soft brush. Don't use a hard tool to scratch the surface.
3) Rinse the base reservoir in clean water.
4) Do not use soap, solvent or a spray on cleaning agent to clean the transducer.
To clean the water tank:
1) Clean the water tank using a soft cloth and with vinegar if there is scum OR limescale inside.
2) If the safety cut-out is covered in scum, put a few drops of vinegar on it and clean it with the soft brush.
3) Rinse the water tank in clean water.
Storage:
Store the device in a clean, dry place, out of the reach of children, having cleaned and dried it.
BREAKDOWNS AND SOLUTIONS
If the Aroma does not operate properly under normal conditions of use, consult the following table:
Problem
Unit neither
blows nor
produces mist
Unit blows but
with no mist
production
Mist with unusual
smell
4
Possible causes
No indicator light.
Main switch turned off.
The water level in the groove is too high.
Water reservoir leaking.
No water in the reservoir
The temperature of the unit is too low.
The water has been left in the reservoir
for too long.
Corrective action
Check that the unit is plugged in.
Switch on the main switch.
Remove the water from the groove.
Check that the cover is closed correctly
Fill up the reservoir
Place the unit in the room at ambient
temperature for half an hour before
use.
Clean out the reservoir and add fresh
water.