Adjusting Mounting Rail Depth; Mounting The Enclosure; Wall Mounting - Tripp-Lite SRDVRLB Manual Del Propietário

5. Enclosure Configuration

5.4 Adjusting Mounting Rail Depth

Warning: Do not attempt to adjust rails while equipment is installed in the enclosure.
Do not attempt to use rails without screws installed (two per rail).
The two mounting rails are pre-installed to accommodate equipment with a mounting depth of
16.25 inches (412 mm). Do not adjust the mounting rails unless your equipment requires a
different mounting depth. The front and rear sets of rails can be adjusted independently in 1-inch
(25 mm) increments for mounting depths between 1 inch (25 mm) and 16 inches (406 mm).
Each rail is connected to the enclosure with two screws: one in the upper corner and another in
1
the lower corner. Using a Phillips-head screwdriver, remove the screws that fasten the rails to
the enclosure.
2 Slide the mounting rails to the desired depth and reattach them using the screws you removed in
Step 1.

6. Mounting the Enclosure

6.1 Wall Mounting

Warning: The enclosure supports 60 lb. (27 kg) of total equipment weight. Install the cross support brace inside the enclosure for
heavy equipment installations. Do not attempt to mount the enclosure to the wall with equipment in the enclosure.
Note: Enclosure must be installed by a qualified technician. Before mounting, use a level and tape
measure to position your mounting area precisely. Use appropriate fasteners (not included) to secure the
enclosure to the wall. Use suitable mounting means when installing to cinder block, concrete, drywall or
wood studs. Warning: The supporting surface must be able to safely support the combined load of
the equipment and all attached hardware and components.
There are two keyhole slots and two support mounting holes on the back of the enclosure. Each
1
keyhole can accommodate an M8 or 5/16" bolt. The holes are spaced 16" (406 mm) apart
horizontally and 5.9" (150 mm) apart vertically, as shown in the diagram.
Note: The below wall-mounting instructions and diagrams are for mounting into wood studs. For solid
or hollow wall-mounting, first check that any anchors used are capable of supporting the weight of
the enclosure and its contents.
2 Using a tape measure and level, identify the wall location you want to position your enclosure
and mark two mounting holes 16" (406 mm) apart. Then insert two M8 or 5/16" bolts into the
mounting hole markings. Upon inserting the hardware, make sure to leave a 1/8" (3.18 mm)
space between the bolt head and the wall.
With the help of an assistant or mechanical lifting device, hang the enclosure's keyholes onto
3
the bolts attached to the wall. The keyholes will fit over the bolts and the enclosure should slide
down until secure. Tighten the bolts once it is determined that the enclosure is safely
supported.
4 Secure the enclosure to the wall by fastening two user-supplied M8 or 5/16" bolts through the
support mounting holes.
continued
6
6
(152 mm)
1
2
3
4