Mounting Rails; Adjusting Mounting Rail Depth; Wall Mounting The Enclosure; Mounting - Tripp-Lite SmartRack SRW18US13 Manual Del Propietário

5. Enclosure Configuration

5.5 Mounting Rails

The enclosure comes with mounting rails that have square holes (default position) and tapped holes
for mounting rack equipment. To install equipment, use the included cage nuts and other hardware.
(See page 7 for installation of cage nuts.) Warning: Be sure to have the enclosure securely
mounted to the wall, or in its final position on the floor before mounting any equipment
inside. Also be sure to have all the right adjustments on your rails before mounting
equipment. (See below for Adjusting Mounting Rail Depth.)

5.6 Adjusting Mounting Rail Depth

Warning: Do not attempt to adjust rails while equipment is installed in the enclosure. Do
not attempt to use rails without screws installed. (2 per rail.)
The 2 adjustable mounting rails are pre-installed to accommodate standard equipment. Do not
adjust the mounting rails unless your equipment requires a different mounting depth.
1 Each rail is connected to the enclosure with 2 screws and 2 cage nuts: 1 set in the upper
corner and another in the lower corner. Using a Phillips-head screwdriver, remove the screws
that fasten the rails to the enclosure.
Move cage nuts to desired depth and reinstall.
2
3 Slide the mounting rails to the desired depth and reattach them using the screws you removed
in Step 1.

6. Wall Mounting the Enclosure

Warning: Do not attempt to mount the enclosure to the wall with equipment mounted in the enclosure.

6.1 Mounting

There are 16 keyhole cutouts on the back door of the enclosure. Each keyhole can accommodate
an M5 or 3/16" bolt. The holes are centered 16" apart horizontally to accommodate the standard
placement of wall studs. Holes are then 28.4" apart vertically, as shown in the diagram.
Using a level, measure to position your mounting areas precisely. Use appropriate fasteners (not
included) to secure the enclosure to the wall. Warning: The hardware you plan to use and the
area you plan to mount the enclosure to must be able to withstand the weight of the
enclosure and all mounted equipment. For the weight of the enclosure and its capacity, see
the specifications on page 7.
12-11-206-93-3281.indd 5
( continued )
5
1
16"
16"
12/21/2012 2:38:16 PM
2
3
28.4"
28.4"