Safety Instructions; Before Using The Device; Packing - AHT M Instrucciones De Uso

User manual M / MV / CT / CMV

1. Safety instructions

Pay attention during and after installation that the device is not positioned on the electric
cable!
Always transport the device in upright position!
If the device is slanted during transport, you must wait at least for two hours before you
start running the device in order to avoid defects!
Pull power plug before each cleaning or maintenance operation or interrupt power supply!
Do not position the device next to a heat source, in supply air or in the current of hot air.
Do not keep or store fuel, gas or other flammable substances close to the cooling unit!
There is risk of fire or explosion due to the escaping vapours.
Keep a distance of at least 8 cm (3.2 inches) between the wall and the rear side in order
that hot air may escape upwards.
Ventilation openings must not be blocked!
Level the device on a solid surface area and set it up in a room which is appropriate for its
dimensions and its purpose of use.
Do not use the cooling unit at a place where the ambient temperature falls below 16° C
(61° F). Set up the device at a dry place.
When setting up the device or when relocating it, pay attention not to damage the floor.
Do not damage the refrigeration circle!
The electric cable must only be replaced by a qualified technician!
Do not use any extension cords or multiple plugs!
The disconnection of the power supply must be possible by pulling the power plug or by a
two-pole switch which is switched before the socket.
This operating instruction is part of the device. Therefore, it must remain with the device!

2. Before using the device

Check the device for damages after unpacking. Report possible damages immediately to
the fright carrier!
Wait for two hours before starting up the device in order that the cooling circuit is able to
achieve its entire functionality.
The installation and the electrical connection must be appropriately prepared by a
qualified person according to the valid regulations.
Before starting up the device, you must clean its inside!

3. Packing

The packing material can be completely recycled and is marked by a recycling symbol.
Dispose according to the local regulations.
Store packing material (plastic bag, polystyrene parts, etc.) out of the range of children.
AHT Cooling Systems GmbH – NL Deutschland
Sonntagshornstraße 19 · 83278 Traunstein
10
· Germany · Tel. +49/(0)861/209 32-0 · Fax +49(0)861/209 29-90 · Email worldwide@aht.at