Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
FOR YOUR SAFETY
•
Two people should be used when moving the wine cooler.
•
Remove interior and exterior packaging prior to installation.
•
Before connecting the appliance to a power source, let it stand upright for approximately 4 hours;
this will reduce the possibility of a malfunction in the cooling system from handling during transpor-
tation.
•
Place your wine cooler on a fl oor that is strong enough to support it when it is fully loaded. To level
your wine cooler, adjust the front leveling leg at the bottom of the unit.
•
Locate the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight and heat sources may increase electrical consumption. Extreme cold ambient tem-
peratures may also cause the unit to perform improperly.
•
Avoid locating the unit in moist areas.
•
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions con-
cerning power and/or grounding should be directed toward a certifi ed electrician or an authorized
service centre.
•
Do not cover shelves with aluminum foil or any other material which may prevent air circulation.
•
In order for the cabinet to remain effi cient do not over load it.
•
Do not open the door unless necessary.
•
Should the wine cooler be stored without use for long periods, it is suggested, after careful clean-
ing, to leave the door ajar. This will allow air to circulate inside the cabinet in order to avoid pos-
sible formations of condensation, mold and odors.
IMPORTANT WARNING
Risk of fi re or explosion due to puncturing of refrigerant tubing. Do not use sharp opjects to
aid in defrost. Please handle with care. Keep fl ammable materials and vapors such as gaso-
Disposal of this unit should be in accordance with federal and local regulations.
line away from the unit. Use nonfl ammable cleaner.
SAVE THESE INSTRUCTIONS!
4