ETI Solid State Lighting 53505111 Guía De Uso Y Cuidado página 6

installation (continued)
4
Making direct wire power connections
□ Remove the five screws on the back of the under cabinet light
fixture (A) and open the back plate of the fixture.
□ Determine which knock out hole in the back plate of the under
cabinet light fixture (A) will be closest to the power supply wire
feed and use a screwdriver to remove the knock out.
□ Insert the threaded end of the strain relief (AA) through the knock
out hole from the outside.
□ Feed the flexible whip or NM cable of the power supply through
the strain relief (AA) in the back plate of the under cabinet light
fixture (A) and tighten the clamp until it is secure.
□ Connect the hot and neutral (black and white) wires from the
power supply box to the same color wires from the electrical
box.
□ Connect the green wire from the power supply box to the
grounding wire from the electrical box.
□ Cover the wire connections using wire connectors (not included)
and electrical tape (not included).
□ Tuck all wire connections into the wire compartment in the under
cabinet light fixture (A) and reattach the back plate of the under
cabinet light fixture with the five screws removed earlier.
WarninG: Do not plug in the power cord when the fixture is
direct wired to the power supply to avoid a dangerous situation.
WarninG: Plug in End Cap before connect power.
A
Wire connectors
6
Back Plate
Knock out Holes
AA
AA
A