Descargar Imprimir esta página

Look E-POST 2 EVO Manuales Del Usuario página 22

Ocultar thumbs Ver también para E-POST 2 EVO:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
EN
Your new bicycle requires that the seat tube be cut to fit your personal seat height. For this operation,
it is best that you contact your authorized LOOK retailer.
1.
Introduce the seatpost into the frame and adjust the horizontal position of the saddle.
2.
Before cutting, measure the saddle height of the new bicycle with the saddle in place.
3.
Calculate the length "L" to be cut using the following formula: L = seat height on the new bike -
personal seat height
4.
Remove the seat post.
5.
Place a strip of adhesive tape, centered on the length "L", in order to protect the post while cutting
6.
Install the cutting tool as necessary and
according to the "L" position and tighten to 3
Nm. (Fig.13)
7.
Cut the tube using a saw (24 or 32 teeth/inch)
inserted into the tool's sawing slot. Position the
bicycle in the stand in such a way as to saw in
a vertical position.
8.
Remove the cutting tool and deburr the end of
the tube with a piece of fine grain sand paper.
Verify that the end of the tube is clean and free
of paint.
Note : The maximum overlap "L" of the tube is 150 mm in relation to the original length.
ADJUSTMENT OF THE SEAT TUBE HEIGHT
You can adjust the saddle height by adding
more spacers. THE E-POST 2 EVO comes with
the following spacers: 1mm (qty. 1) / 2mm (qty.
2) / 5mm (qty. 1) / 10mm (qty. 3). The maximum
height allowed for the added spacers is
30mm (i.e. 3x10mm spacers, stacked). To
adjust your seat height:
1.
Loosen the 2 EVO E-Post and remove it
from the frame.
2.
Place the spacers on the seatpost as
indicated on fig. 14.
3.
Install the seat post as per the procedure
previously provided.
22
CUTTING THE SEAT TUBE HEIGHT
Fig 13
L
Fig 14

Publicidad

loading