Electrode Welding - ims PRO GOLD Multi 200-2 Manual Del Usuario

To adjust the roller tension (fig C), process is as follows: loosen the tensioner to the maximum (4), start the motor by pressing the
torch trigger, tighten the tensioner whilst pressing the trigger. Bend the wire where it comes out of the nozzle and hold it in place to
stop its progress. The pressure adjustment is ideal when the guide roller slides over the wire even when it is blocked at the end of
the torch.
NB: for aluminium wire set the tension to the minimum not to pinch the wire.
• Adjust the wire so 5cm protrudes from the torch then fit the contact tip (correct tip for the wire) (fig D) and the nozzle (fig E).
GAS CONNECTION
The device is designed with a quick release gas connection. Use the adaptor supplied with the machine.
FE
Type of wire
MAG
Process
Ar+CO²
Gas
0.6 - 0.8 0.6 - 0.8
Ø available
- 1.0
Welding
All
position
MMA
• Selecting MMA mode
• Welding current adjustment
• Arc Force adjustment
• Hot Start adjustment

ELECTRODE WELDING

• The reverse polarity cable must be disconnected in MMA (stick welding) mode in order to connect the electrode holder and earth
clamp. Connect the electrode holder and earth clamp as indicated on the electrode packaging.
• Respect the basic rules of welding
• This device has 3 features specific to Inverter machines :
- Hot Start: Increases the current to assist the initial striking of the arc.
- Arc Force: A ponctual increase of current avoiding the electrode to be stuck in the welding pool.
- Anti-Sticking: Enables easy removal of the electrode from the metal.
TIPS :
Low Hot Start for thin metal sheet and high Hot Start for more difficult metal to weld (dirty metal or oxidised).
GOLD MULTI 200.2 / 200.4 XL / 201.4
FE ALG 5 SS
MAG MIG MAG
CO² Ar
Ar+CO² 2%
0.8 - 1.0 0.8 - 1.0
- 1.0
All All All
Keep button 2 pressed and at the same
time turn the upper knob to select MMA
mode.
Turn the upper knob to select the wel-
ding current.
Turn the lower knob to adjust the Arc
Force.
Adjustable from 0 to 100%
Keep pressing button 3 and at the same
time turn the upper knob to adjust the
Hot Start.
Adjustable from 0 to 100%
FC CuSi 3 CuSi 8
MAG MIG MIG
Ar Ar
0.9 -1.2 0.8 0.8 - 1.0
All Flat Flat
CuAL ALSi 5
MIG MIG
Ar Ar
0.8 1.0
Flat All
+
+
EN
ALSi 12
MIG
Ar
1.0
All
23