Descargar Imprimir esta página

DOMUS LINE LOOP Manual De Instalación página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

INSTALLATION MANUAL
INSTALLATION OF LOOP Magnet AND PULSE Magnet
The LOOP Magnet and PULSE Magnet devices can be
installed directly on the surface of the glass of a mirror
appropriately fitted with a metallic sheet. The device is
guaranteed to adhere perfectly for installation on mirrors no
thicker than 6 mm with a ferrous metallic sheet applied on
the back at least 0.6 mm thick.
- On the rear of the mirror (D) install a ferrous metallic sheet
(E) at least 0.6 mm thick in correspondence with the point
where you intend to mount the light (F) as illustrated in
figure 3.
- Apply the device on the surface of the mirror, taking care
not to allow the power cable to come into contact with
sharp edges.
CONNECTION OF THE DEVICE TO THE POWER SUPPLY
- Connect LOOP and PULSE only to a safe power supply with
12Vdc stabilised voltage (sold separately) and with power at
least 10% higher than the total load. For the total load
calculation check plate data printed on the product label.
- LOOP and PULSE have a connector (G) that allows
connection to a DOMUS Line compatible power supply.
EN
Check the type of connector and select a type of power
supply compatible with it. For more information go to
www.domusline.com or contact us.
- If more than one device must be connected to the power
supply ensure that the total sum of the power absorbed by
the devices (check the plate data shown on the product
label) does not exceed the maximum power permitted by
the Converter.
- DOMUS Line guarantees the product only if powered with a
Converter supplied by us.
WARNING
- The LED module for these devices cannot be replaced and
therefore in the event of failure the entire device must be
completely replaced.
- Do not use the device if the power cable and/or the
connection cables are defective. Defective cables and/or
connectors must be immediately replaced by qualified
personnel authorised by DOMUS Line.
- Never run any cable through sharp corners and edges.
- Never run the cable over hot parts and always protect it
against contact with liquids.

Publicidad

loading

Este manual también es adecuado para:

Pulse