Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Instructions for Mobile Bases
1.
Be careful when moving to limit any finger pinch points.
2.
Place base on a level surface and adjust levelers before placing the machine in position. This should keep the
machine from rocking, while testing it for stability.
3.
Test the stability in both the up (on the casters) and the down positions. Exercise caution when testing the
stability of top heavy machines (drill presses, band saws, etc.).
4.
Unplug any power tool before moving or repositioning your tool.
5.
Always test your set-up for stability and safety after repositioning.
6.
Care should be taken when planning the orientation of the machine onto the Universal Mobile Base. Transfer
the weight off of the levelers to the casters will result in the machine tilting 1/2" (13 mm) toward the fixed
wheels. When positioning top heavy tools such as a drill press or band saw, take advantage of the center of
gravity, and position so that it will remain stable while on casters.
7.
Never use your machine without engaging the floor locks and foot locks. Always lower the machine onto the
non-skid levelers before operating.
8.
When moving, always push the base, not the machine.
Assembly Instructions
Tools required: Adjustable wrench, tape measure, drill, ½" (13 mm)
drill bit, and a Philips screwdriver
1. Unpack and identify all components and hardware. Make
sure there are no missing parts and that there is no shipping
damage.
Note: Read instructions thoroughly before proceeding.
2. Assemble the front corners:
a.
Thread the rubber glide foot H into the bracket,
then thread the jam nut onto the top
b.
Attach the wheel F to the swivel plate M.
c.
Install the swivel plate using the M8-85 carriage bolt
N, lock washer P, and nut G. Tighten.
d.
Install the foot lever R using the M8-85 carriage bolt
N, nylon washers O, lock washer P, and nut Q.
2 a.
2 c.
2 d.
4
G
P
H
N
N
M
F
Q
O
P
R
Publicidad
Tabla de contenido
