Settings In Robo Pro - fischertechnik ROBO RF DATA LINK Manual De Instrucciones

ROBO RF DATA LINK OPERATING INSTRUCTIONS
GB+USA
Interface Firmware
(Operating system for the ROBO interface)
For the correct operation of the RF data link, the interface firmware version 1.53 or higher is needed. The ROBO Pro
version 1.1.2.41 recognizes the version of the firmware and updates it. To do this, the ROBO interface with the installed
radio module is connected with the USB cable to the PC and the interface test is called up in ROBO Pro. If necessary, the
software suggests the updating of the interface firmware. Please follow the instructions.
RF Data Link Firmware
Both radio modules also have their own firmware. ROBO Pro can also identify the version of this firmware and suggest,
if necessary, an update. For the procedures see the chapter 10 "Firmware Update for the Radio Module."

6 Settings in ROBO Pro

In the ROBO Pro software in the interface options, the interface must be set to USB.
In the interface test under the tab, Info, the various parameters for the radio link can be displayed and changed:

The interface−radio module can be activated or deactivated. Through the deactivation, you can prevent the radio recep-
tion of undesired data by the interface from somewhere. Deactivation is only possible if the ROBO interface with the
installed radio module is connected through the USB cable with the PC. The PC radio module cannot be deactivated.
 Write to flash memory: Changes made are transferred to the hardware using this button and remain valid until the next
change is made.
Write to temporary memory: Changes are lost if the power supply to the hardware is interrupted.
10






 Frequency set
(see chapter 7 "Independent Operation of
Several RF Data Links")
 Call signal set
(see chapter 8 "Communications Between
Two Interfaces")
 Firmware version
• of the PC radio module if this is
connected to the USB cable;
• of the interface−radio module if the
interface is connected to the USB cable
and there a radio module is installed
and activated.
See chapter 10 "Firmware Update."