Siemens Gigaset SE505 Guia De Manejo Rapida página 21

Overview of the steps to install a network
1. First install the Ethernet network card or a wireless network adapter such as the
Gigaset PC Card 54 or Gigaset PCI Card 54 in your PC. The installation procedure is
described in the operating instructions for these products.
When installing a wireless network adapter, please note:
i
The factory set SSID of the Gigaset SE505 dsl/cable is
ConnectionPoint.
2. Now install the Gigaset SE505 dsl/cable.
– Connect the Gigaset SE505 dsl/cable (see page 20).
– Set up the network (see page 23).
– Configure the Gigaset SE505 dsl/cable (see page 25).
For this you will need the access data for your Internet Service Provider.
These steps are described on the following pages. You will need around
10-15 minutes to complete them.
3. If you are using a wireless connection, set up the connection from the wireless
network adapter to the Gigaset SE505 dsl/cable. This is described in the operating
instructions for the network adapter.
4. You can also connect further PCs and configure them as described on page 28.
Quick Installation Guide
19