Cleaning The Cooling Unit - Unit Cover Removal - Pfannenberg Premium Controller X Serie Instrucciones De Servicio

GB
5.2

Cleaning the cooling unit - Unit cover removal

Item Designation
1 Fastening screws
4 Bottom plate slot
Requirement
The cooling unit is de-energized
-
Procedure
 Remove the fastening screws (1).
 Tilt the unit cover (5) forward 20° (2).
 Disconnect the ground cable and connecting cables from the control panel (inside) (3).
 Raise the unit cover about 15 mm and pull it out of the slots in the bottom plate (4).
 The unit cover is removed.
Operating Manual DTS and DTI 6X1E Premium Controller X-Series (XC) 086100018 © Pfannenberg GmbH
1
5
Figure – Unit cover removal
17
Item Designation
2 Tilting angle 20°
5 Unit cover
1
2
3
4
Item
3
Designation
Display or operating unit
Page 33 / 40