Removing Infant Car Seat From Stroller; Removing Icsa And Arm Bar From Stroller - Britax B-LIVELY Guia Del Usuario

Removing Infant Car Seat from Stroller

1. Set parking brake (see stroller user
guide if necessary).
2. Activate Click & Go release handle on
infant car seat then lift infant car seat
straight up and off stroller with infant
car seat carry handle.

Removing ICSA and Arm Bar from Stroller

1. Set parking brake (see stroller user
guide if necessary).
2. Remove arm bar by pushing buttons
under receivers and pulling arm bar
away from stroller.
3. Press the release levers on the sides
of the ICSA receivers and the arm bar
receiver, and pull receivers up and out
of mounting brackets.
NOTE: The release lever on the arm
bar receiver is on the inside of the
receiver.
10
4. Install canopy.
a. Place the canopy stay bracket over
b. Snap the outer support strap to the
c. Insert the inner support strap
d. Attach the hook and loop fasteners
Release
Lever
the mounting pin on the side of the
stroller frame and rotate until the
canopy stay bracket locks into place.
NOTE: There is a left and a right
canopy. Install each canopy so that
the canopy brackets face the outside
of the stroller frame.
frame on the outside of the stroller
handle, and tighten the support
strap by connecting it to the hook
and loop fastener under the canopy
flap.
through the slot at the center of
the stroller handlebar. Tighten the
support strap by connecting them
to the hook and loop fasteners
under the canopy flap.
around the outer edge of the canopy
and hood to the stroller.
11