Placing Tool In Service - Ingersoll Rand 291 Instrucciones

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll–Rand No. 50
Always use of an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International– No. C26–C4–A29
For U.S.A. – No. C22–04–G00
After each forty–eight hours of operation or as
experience indicates, remove the Oil Chamber Plug (11)
and fill the oil chamber with the recommended oil.
Model Type of
Handle
291, 291–EU pistol
291–6, pistol
291–6–EU
291–S pistol
H
Tested in accordance with ANSI S5.1–1971 at free speed
Tested to ISO8662–1 loaded with frictionbrake to 9 RPM
ISO3744
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620 kPa)

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 100
SPECIFICATIONS
Drive Impacts
per min.
in.
1" sq. 700
1" sq. with 6" 700
extended anvil
No. 5 spline 700
dr. anvil
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Recommended
Torque Range
ft–lbs (Nm) Pressure
100–900 101.3
(136–1102)
100–900 101.3
(136–1102)
100–900 101.3
(136–1102)
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)
HSound Level
Vibrations
dB (A)
Power
114.3
114.3
114.3
Level
2
m/s
4.2
5.7
4.2