Philips 3100 Serie Manual Del Usario página 28

English
28
Problem
The coffee is watery.
The coffee is not hot
enough.
Coffee is leaking from
the coffee dispensing
spout.
Coffee does not come
out or coffee comes
out slowly.
Cause
The machine is still in the
descaling procedure.
The grinder is set to a too
coarse setting.
The coffee exit duct is
clogged.
The machine is performing
its self-adjustment
procedure.
The brew group is dirty or
needs to be lubricated.
The cups you use are cold.
The temperature is set too
low. Check the menu
settings.
You added milk.
The coffee dispensing spout
is clogged.
The coffee exit duct is
clogged
The AquaClean filter was not
prepared properly for
installation or it is clogged.
The grinder is set to a too
fine setting.
Solution
You cannot remove the brew group
when the descaling procedure is in
progress. First complete the
descaling procedure and then
remove the brew group.
Set the grinder to a finer (lower)
setting.
Clean the coffee exit duct with the
spoon handle. Then turn the
machine off and on again.
Brew a few cups of coffee.
Clean and lubricate the brew group.
Preheat the cups by rinsing them
with hot water.
Set the temperature to 'high' in the
menu.
Whether the milk you add is warm or
cold, it always decreases the
temperature of the coffee to some
extent.
Clean the coffee dispensing spout
and its holes with a pipe cleaner.
Clean the coffee exit duct with the
handle of the measuring spoon or a
spoon handle. Then turn the
machine off and on again.
Remove the AquaClean filter and try
to brew a coffee again. If this works,
make sure the AquaClean filter is
prepared properly before you place
it back. Place back the prepared
filter. If this still does not work, the
filter is clogged and needs to be
replaced.
Set the grinder to a coarser (higher)
setting.