Cleaning Instructions - Weston PRO Serie Manual De Instrucciones

CLEANING INSTRUCTIONS

WARNING!
Before cleaning, assembling or disassembling the
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
1. Remove the Head Assembly from the Grinder Motor.
2. Disassemble the Head Assembly.
3. Remove the Safety Guard from the Tray, as instructed in the "Safety Guard
Instructions". Safety Guards only come with #22 and #32 Model Grinders.
4. Wash all parts that have come in contact with meat in hot soapy water. BE SURE
TO CLEAN IMMEDIATELY AFTER USE.
WATER OR OTHER LIQUIDS!
5. Rinse the Grinder parts with clear hot water, then dry them IMMEDIATELY.
6. Fully lubricate the Head, Plates and the Knife with a food-grade silicone spray
before and after each use.
7. Clean the Motor Cover and Gear Housing with a damp towel and wipe dry.
NOT IMMERSE THE MOTOR IN WATER OR OTHER LIQUIDS!
IMPORTANT: Any metal parts must be coated with a food-safe silicone spray to
prevent rusting; if not properly protected, these parts will begin to rust very quickly.
DO NOT use rusted parts. Ordering information can be found on the last page of
this instruction manual.
8. Reinstall the Safety Guard onto the Tray, as instructed in the "Safety Guard
Instructions". Safety Guards only come with #22 and #32 Model Grinders.
9. Reassemble the completely dry Grinder for storage.
WARNING!
NEVER operate Grinder without the
Tray/Safety Guard secured in place.
To avoid serious or fatal injury, NEVER reach
ALWAYS use the Stomper to push meat
Read & fully understand all instructions
DO NOT IMMERSE THE MOTOR IN
into any Grinder inlet.
into the Grinder Head.
& warnings prior to use.
-7-
DO