Operating Tips; Operating Instructions - VWR 1000 Manual De Instrucciones

o I - s
PEratINg NstrUCtIoNs taNdard
The Standard Orbital Shaker is used for general laboratory shaking needs.
1. getting ready:
a.The speed knob should be at the extreme counter-clockwise position or at
the #1 on the dial.
b. Make sure the rocker switch is in the stanby position.
c. Plug the cord into a properly grounded outlet.
2. setting speed:
a.To run push rocker to the on position. Set speed knob to desired setting and
if necessary. Unit will run until you move the rocker switch to the off position.
The microprocessor speed control slowly ramps to set speed to avoid splash-
ing.
3. turning unit off:
a. To stop shaking function, turn the speed knob to the extreme counter-clock-
wise position and push the rocker switch to the standby position. The shak-
er should be kept in the standby position when not in use. To completely cut
off power to the unit, disconnect the power cord from the unit or unplug from
the wall outlet.
5
o s
rbItal HakEr

oPEratINg tIPs

Centering your sample and even weight distribution on the tray helps with balance and
stability.
The shaker will automatically restart after a power interruption.
EN