Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2.0 Installation
2.1 Viewing Angle
Grafica's graphic LCD screen is best viewed from an angle between 20°
and -10° (Figure 1 on page 32). Be sure to install the Grafica keypad at a
height and in a direction that provides the best viewing angle.
2.2 Keypad Cover Clearance
Grafica's keypad cover requires sufficient space in order to open properly.
Ensure a clearance of approx 9cm (3.5") between the bottom of the keypad
and possible obstructions such as a light switch that may prevent the
keypad from opening properly (Figure 2 on page 32).
2.3 Mounting the Metal Wall Plate
1. Place metal wall plate to desired position.
2. Drill and insert screws into holes labeled "A" (Figure 3 on page 33). Both
the top and bottom center holes "C" can be used for an electrical box.
2.4 Connecting Grafica
You can connect Grafica to the control panel's communication bus in a star
and/or daisy chain configuration. The communication bus consists of four
wires that provide power and two-way communication between the control
panel and all modules connected to it. Connect the four terminals labelled
,
,
RED
BLK
GRN
control panel (Figure 4 on page 33). Please refer to the appropriate control
panel's Reference & Installation Manual for maximum allowable installation
distances.
2.5 Mounting Grafica
1. Place Grafica's back plate flush against the mounted metal wall plate.
2. Slide Grafica's open slots labeled "A" (Figure 5 on page 34) onto the
metal wall plate's tabs labeled "B" (Figure 6 on page 34).
3. Gently apply downward pressure to snap Grafica onto the metal wall plate.
4. You may insert an optional screw under the Grafica keypad through the
space in the metal wall plate's left tab (Figure 6 on page 34).
2.6 Unmounting Grafica
1. If required, remove the optional screw (Figure 6 on page 34).
2. Gently lift the unit upwards with your hands until it separates from the
metal wall plate (Figure 7 on page 35).
4 Reference & Installation Manual
and
of the module to the corresponding terminals on the
YEL
Publicidad
Tabla de contenido
