Sensor Data Transmission; Clock; Clock Reception; Manually Set Clock - Oregon Scientific DP200 Manual Del Usario

SENSOR DATA TRANSMISSION

The main unit will automatically search for the outdoor
sensor. The sensor reception icon in the remote sensor
area shows the status:
ICON
and "--.-
NOTE If the sensor is not found, check the batteries,
obstructions and remote sensor location.
For best results:
• Place the sensor out of direct sunlight and rain.
• Position the sensor facing the main unit, minimizing
obstructions.
• Place the sensor in a location away from metallic or
electronic objects.
• Position the sensor closer to the main unit during
cold winter months.

CLOCK

CLOCK RECEPTION

This product is designed to synchronize its clock
automatically with a clock signal.
DESCRIPTION
Main unit is searching
for sensor(s).
A channel has been
found.
Sensor 1 data
received.
The sensor cannot
"
be found.
DP200:
Slide EU / UK to select the signal received.
• EU: DCF-77 signal: within 1500 km (932 miles) of
Frankfurt, Germany.
• UK: MSF-60 signal: within 1500 km (932 miles) of
Anthorn, England.
DP200A:
• WWVB-60 signal: within 3200km (2000 miles) of
Fort Collins Colorado. Manually set clock to select
time zone (Pacific, Mountain, Central or Eastern).
To enable / disable signal reception:
to
Press and hold
reception.
NOTE Reception takes 2-10 minutes. If the signal is
weak, it can take up to 24 hours to get a valid signal.
Clock signal reception indicator:
STRONG
WEAK SIGNAL
SIGNAL

MANUALLY SET CLOCK

To set the clock manually, disable the signal reception
first.
1. Press and hold SET CLOCK.
2. Press or to change the settings.
4
enable or to disable signal
NO SIGNAL