Controls And Jacks - RS Pro RS-9660B Manual De Instrucciones

Heavy Duty True RMS Digital Multimeter / English
Equipment complies with current EU directives.

2. Controls and Jacks

1. LCD Display
1
2. HOLD Button
3. RANGE Button
4. MAX/MIN Button
2
5. PEAK Button
6
3
6. MODE Button
7. Backlight Button
8
8. Function Switch
9. 10A Input Jack
10. mA uA Input Jack
9
11. Positive Input Jack
10
12. COM Input Jack
3. Symbols and Annunciators
• )))
Continuity
Low Battery
Diode test
HOLD
Data Hold
AUTO AutoRanging
AC Alternating Current or Voltage
DC
Direct Current or Voltage
V Volts
A, mA, uA Current range
2
4. Operation
Turn the range knob from the OFF position to any measurement range.
Note:
For best battery life, ALWAYS turn the function switch to the OFF position when the
meter is not in use. This meter has 'Auto OFF' that automatically shuts the meter off if 30
minutes elapses between use.
NOTE: On some low AC and DC voltage ranges, with the test leads not connected to a
device, the display may show a random, changing reading. This is normal and is caused by
5
the high-input sensitivity. The reading will stabilize and give a proper measurement when
7
4
connected to a circuit.
4-1. MODE Button
To select AC or DC measurement when in Voltages, Amps, mA, uA, Ω,
4-2. HOLD
HOLD key is the reading hold control key that acts with trigger. The function is to hold the
11
display of the reading. Pressing the key will display the value and will be locked and kept
12 unchanged. Pressing the key again, the locked status will be erased and enter the normal
measurement status.
4-3. RANGE Button
When the meter is first turned on, it automatically goes into AutoRanging. This
automatically selects the best range for the measurements being made and is generally
the best mode for most measurements. For measurement situations requiring that a range
be manually selected, perform the following:
1. Press the RANGE button. The "Auto Range" display indicator will turn off, The
"Manual Range" display indicator will turn on
2. Press the RANGE button to step through the available ranges until you select the range
you want.
3. Press and hold the RANGE button for 2 seconds to exit the ManualRanging mode and
return to AutoRanging.
4-4. PEAK Button
PEAK Key is the peak value measurement key that acts with trigger. Except Hz
/Ω/Diode/, Continuity and Temp, other functions can do the peak value measurement.
16/12/2017 Version No. 001 16/12/2017 Version No. 001
Heavy Duty True RMS Digital Multimeter / English
, • ))), CAP, Hz.
3