Technical Specifications; Insert Batteries - Sinji Pulse Oximeter Manual De Instrucciones

PULSE OXIMETER
What does the
measurement mean?
A normal saturation value
(SpO2) is between 95-100%.
A value below 90% can indicate
health problems. In general,
the resting heart rate for adults
is 60-100 BPM. Consult
your physician to determine
a diagnosis if the SpO2 and
/ or heart rate measurement
deviates from the reference
values.
DESCRIPTION
The Sinji Pulse Oximeter is a portable device with which the oxygen
saturation and pulse (heart rate) can be measured via the finger.
Thanks to the advanced DSP algorithm, measurements are very
accurate. This oximeter is easy to use and suitable for consumers
and professionals.
IN THE BOX
1x Sinji Pulse Oximeter
1x Cord
1x Manual
Factory: Xuzhou Yongkang Electronic Science Technology Co. Ltd.
0123
4F Building C8, 40 Jingshan Road, Economic and technological
Development Zone, 221000 Xuzhou, People's republic of china
ec rep: Prolinx GmbH
Brehmstr. 56, 40239, Dusseldorf
Germany

TECHNICAL SPECIFICATIONS

Model Sinji Pulse Oximeter
Display system OLED
Power supply 2x AAA batteries 1.5V
Measurement range Oxygen saturation: 70% - 100%,
pulse: 30 - 254 bpm
Accuracy Oxygen Saturation: ± 3%, pulse ± 2BPM
Automatically off after 8 seconds
Dimensions 5.8 x 3.6 x 3.3 cm
Weight 50 g

INSERT BATTERIES

Before use, insert two AAA batteries into the device. Open the
battery compartment and observe the polarity as indicated in
the battery compartment. Close the battery compartment after
insertion.
ATTACHING THE CORD
Attach the supplied carrying loop by putting it through the hole.
INSTRUCTIONS
1. Open the finger hole by squeezing the part marked "push".
2. Place one of your fingers into the rubber finger hole.
3. Press the start button to start the measurement.
4. Keep your finger and body as still as possible during the
measurement for best results.
5. After a short while, the pulse rate and measured oxygen
saturation will be indicated on the display.
6. Remove your finger from the finger holes and the device will
automatically turn off after 8 seconds. Clean the rubber part after
use.