Safety Tips; Problems And Solutions - Sinji Pulse Oximeter Manual De Instrucciones

SAFETY TIPS

• This device should not be used in the vicinity of magnetic
resonance imaging (MRT) or computer tomographs (CT).
• Do not use the oximeter in the vicinity of explosive, resp.
flammable materials - risk of explosion!
• The device is not suitable for continuous monitoring of oxygen
saturation in the blood
• Finger and device must be clean so that a problem-free
measurement can be taken.
• Inaccurate measurements can also arise in case of:
o Dysfunctional hemoglobin or low hemoglobin level
o Use of intravascular dyes - Bright environment - greater hand
or body movements
o Use of electrosurgical interferences and high frequency
defibrillators
o Venous pulsation artifact
o Simultaneous use of blood pressure monitor cuffs, catheters or
intravascular ports
o Patients with high blood pressure, vasoconstriction, anemia or
hypothermia
o Cardiac arrest and shock states
o Artificial fingernails
o Circulation disorders
• The oximeter is only an additional aid in assessing the patient's
situation.
• Electrosurgical instruments can impair the performance of the
device
• The health situation can only be determined when a doctor has
more clinical, resp. conduct professional investigations
• During prolonged use or after use on each patient, the
measuring point should be changed regularly. The measurement
point should be changed every 4 hours, checking the skin
integrity and circulatory status of the patient.
CLEANING
Remove the batteries before cleaning the device. Never use
aggressive cleaning agents or hard brushes. Clean the device with
a soft cloth slightly dampened with isopropyl alcohol. Moisture must
not penetrate into the device. Do not use the device again until it is
completely dry.

PROBLEMS AND SOLUTIONS

Problem Cause
Oxygen saturation or 1. The finger is not
pulse does not display properly inserted in the
properly finger hole.
2. The user's oxygen
saturation is too low and
cannot be measured.
Oxygen saturation or 1. Finger is not far enough
pulse is unstable in the device.
2. The finger or body is
moving too much.
The device does not 1. The batteries are empty.
turn on 2. The batteries are not
properly inserted in the
device.
3. The device is damaged.
The backlight of the 1. If no finger is detected,
screen suddenly turns off the device will turn off
automatically after 8
seconds.
2. The battery has
insufficient power.
Solution
1. Place the finger
correctly in the finger hole
and try again.
2. Verify that the device
is working properly by
taking a measurement on
another person.
1. Place the finger
correctly in the finger hole
and try again.
2. Try to keep your body
still.
1. Replace the batteries
2. Check if the batteries
are installed correctly
3. Contact customer
service
1. Place your finger in the
finger hole and try again
2. Replace the batteries