Publicidad
Idiomas disponibles
Idiomas disponibles
NOTES:
1. Use Coleman
®
propane cylinders. The LP-gas
cylinder(s) used with lanterns must
be constructed and marked in
accordance with the specifications
for LP-gas cylinders of the U.S.
Department of Transportation or
Transport Canada, CAN/CSA B339.
2. Replace any mantle with a hole in it. A
hole can cause lantern to overheat and
create a hazard. Never operate lantern
without heat shield.
■ Take lantern outdoors away from
ignition sources.
■ Turn fuel valve off. (Fig. 6)
■ Remove protective cap from top of
propane cylinder. Save cap for use in
storing. (Fig. 7)
Fig. 6
■ Screw propane cylinder into lantern.
Take care not to cross-thread. Hand
tighten only. (Fig. 8)
■ Unfold cylinder base as shown.
■ Place cylinder securely in lantern base.
(Fig. 9)
Fig. 8
■ Assemble reflector to back of lantern.
Align grooves on reflector with the two
back rails. Push reflector until it snaps
onto back rails. (Fig. 10 and 11)
■ Storage position. Reflector snaps to
the beads on the back of collar.
(Fig. 12 and 13)
Fig. 10
Bead
Fig. 12
16.4 oz. disposable
• Keep all connections and fittings
clean. Inspect propane cylinder and
lantern propane connections for
damage before attaching.
• During set up, check all connections
and fittings for leaks using soapy
water. Bubbles indicate a leak. Never
use a flame.
INSTASTART™
Electronic Ignition Lantern
■ Turn fuel valve on. Push the green
igniter button and a spark should
jump between the electrode and lower
mantle support and ignite the mantle.
(Fig. 14)
Fig. 7
NOTE: If lantern does not light after
pushing the igniter button a few times,
repeat above step after turning fuel valve
completely off. If the lantern is wet due
to rain, high humidity, etc., the valve may
not spark. Use match lighting procedure
as follows.
Match Light Lantern
■ Push lighted match through lighting
hole, hold near mantle and open fuel
valve fully. (Fig. 15)
Fig. 9
■ Brightness can be adjusted with fuel
valve. (Fig. 16)
Fig. 11
Fig. 13
English - 5
CAUTION
SERVICE SAFETY
Fig. 14
Fig. 15
Fig. 16
Publicidad
