Descargar Imprimir esta página

Braun Shave&Shape 5596 Manual De Instrucciones página 8

Ocultar thumbs Ver también para Shave&Shape 5596:

Publicidad

Idiomas disponibles

Idiomas disponibles

trimmer
simultaneously (c). First the
longhair trimmer
«problem hairs»; then the foil
follows to give a close, smooth shave.
Using the longhair trimmer and the foil
simultaneously ensures that the sha-
ver is held in the right position as it
travels over the skin.
For combination shaving, push the
switch
up to «longhair trimmer».
Longhair trimming
To use, push the switch
ting «longhair trimmer». This extends
the cutting comb up over the foil for
maximum visual control and precision
when shaping your moustache, side-
burns or shaving off single long hairs
(d).
Switching the shaver off
Push switch
to the «off» setting.
Important: After every shave, put the
foil protection cap
frame
.
Cleaning and maintenance
Turn the shaver off.
After every shave, take off the foil
frame
(e) and tap out lightly the
remaining whiskers on an even
surface.
Clean the cutterblock
cleaning brush
Do not clean the foil with the cleaning
brush to avoid damaging it.
Approximately every four weeks clean
the cutterblock
cleaner to maintain the shaver's top
performance and to keep it hygienic.
8
cuts off the longer
up to set-
back down all the way
over the foil
with the
(f).
with Braun shaver
After every cleaning replace the foil
protection cap
Purchasing spare parts
Buy only original Braun spare parts to
ensure proper maintenance of your
shaver. Parts can be purchased at the
retailer where your shaver was pur-
chased, a Braun Service Center, or
directly from Braun via the enclosed
Accessories Leaflet.
To determine which foil (i) or
cutterblock to purchase, keep in mind
one of the following points:
1) The shaver model number
(on original packaging)
2) The serial number
(below cutterblock)
3) What your shaver looks like
(match up to illustration on spare
parts packaging).
Changing of shaving parts
Foil frame
Remove the frame
is switched off) by pulling at the two
grooved surfaces (e). Put the new
frame onto the shaving head. Do not
press on the foil in order to avoid
damaging it.
Cutterblock
To remove the cutterblock
crosswise and lift it off (g). Replace it
with new cutterblock.
Parts for an automobile or boat
When recharging your shaver in an
automobile or boat use only the
special Braun charging cord
(No. 5-002-707) that is stated on the
packaging for this purpose (available
from a Braun Service Center). For
.
(while the shaver
turn it

Publicidad

loading