Using Your Venti Hot Beverage Maker - Westbend VENTI L5768 Manual De Instrucciones

U
CONTROL BUTTONS:
MIX - Mixes your beverage. Press once for high speed; both
selection indicator lights will illuminate. Press twice for low
speed; the left selection indicator light will illuminate. Pressing
"Mix" will mix only, without heat. "Mix" will operate for 3 cycles
of 1 minute with 5 minute rests in between. After 3 cycles, the
appliance will turn off.
HEAT - Heats and mixes your beverage. "Heat" will mix at
high speed for the first 2 minutes, then will switch to low
speed for the remaining time.
DISPENSE - Mixes your beverage at a high speed, without
adding heat, to mix and froth your beverage for serving. The
selection indicator lights above "Dispense" and "Mix" will be
illuminated.
CANCEL - Stops all functions. "Cancel" can be pressed at
any point in the cycle to turn the appliance off.
The measurements used below produce 72 ounces. Refer to the
Ingredients Chart to determine usage for alternate serving sizes.
1. Place mixing container on to the motor base. Make sure
that it is completely seated, as there is a safety switch that
will not engage if not fully seated.
2. Pour up to 72 ounces of water or milk into the mixing
container. Note: Do not fill the mixing container past the
72 ounce "Max Fill" line.
3. Add your favorite instant drink mix, using the measurements included on the
packaging or given below. Always use instant drink mixes, this appliance can not
brew or steep.
4. Place the cover onto the mixing container, making sure that it covers the pour spout.
5. Plug the Venti Hot Beverage Maker into a 120 volt, AC outlet only.
6. Press the "Heat" button. The selection indicator lights will be illuminated and your
Venti Hot Beverage Maker will begin to mix and heat. When the beverage
reaches the "Perfect Temperature," the appliance will automatically go idle. As
the beverage cools down, the appliance will automatically reheat and remix back
to the "Perfect Temperature." The appliance will remain on until
pressed. "Cancel" may be used at any time to turn the appliance off. Selecting
another setting will change the operation and the selected control button will glow
blue. Note: A full 72 ounces may take up to 15 minutes to reach the "Perfect
Temperature."
7. Once the appliance automatically goes idle, place a cup underneath the
dispensing valve and press the "Dispense" button. This setting will mix the
beverage while you dispense so that a rich layer of froth is dispensed into your
cup along with the hot beverage.
8. Press down on the dispensing valve lever to dispense the hot beverage into your
cup while the motor is mixing the beverage. After dispensing the beverage, press
"Heat" if there is still liquid in the mixing container or press the "Cancel" button if
less than 1 cup of beverage remains.
9. When the container has less than 1 cup of liquid remaining, or is empty, press the
(cancel) button. Note: The appliance will remain on until you press
English - 4
Y V
SING OUR ENTI
H B
OT EVERAGE
M
AKER
(cancel) is
(cancel).