Cleaning Your Venti Hot Beverage Maker - Westbend VENTI L5768 Manual De Instrucciones

C
LEANING
The Venti Hot Beverage Maker must be cleaned after every use. Note: Do not
wash any parts in the dishwasher and do not immerse the motor base or mixing
container in water or any other liquid.
1. Unplug the appliance from the electrical outlet. Allow the entire appliance to
cool before cleaning.
2. Remove the mixing container from the motor base.
3. Pour out any unused portion of the hot beverage mixture.
4. Add hot water and a couple drops of dish soap to the mixing container. Wash and
rinse. Note: For any difficult to remove build-up, use a nylon scrub pad. To
remove build-up around the edge of the mixing container and under the gasket,
use the corner of a nylon scrub pad. It may help to let hot, soapy water sit inside
the mixing container for a few minutes. Do not immerse the mixing container in
water or any other liquid.
5. Separate the cover and cap cover, then remove and disassemble the dispensing
valve as described below. Wash cover, and dispensing valve pieces in hot, soapy
water. Rinse and dry pieces thoroughly before reassembling.
6. Wipe the exterior of the motor base and mixing container with a soft, damp cloth.
7. Periodically sanitize mixing container and gasket. Place mixing container on the
motor base and add 4 cups of water and ¼ tsp. unscented bleach to the mixing
container. Put cover with cap cover on mixing container, and run the appliance
through a complete cycle on "Heat." After cycle, empty mixing container through
the dispensing valve and let air dry.
Stopper Pin and Rubber Stopper
To disassemble the valve for cleaning:
1. Remove the valve from the container by unscrewing the entire valve body
counter-clockwise.
2. Remove the cap by unscrewing it counter-clockwise.
3. Remove the stopper/stopper pin, spring, cap, and lever from the valve body.
Note: The stopper pin and rubber stopper are tightly fit and need not be separated.
4. Compress the cap and stopper together to remove the lever and cap.
5. Clean all parts and reassemble in the order shown.
English - 6
Y V H
OUR ENTI
Cleaning the Dispensing Valve
Cap
B
OT EVERAGE
Lever
Spring
Valve Body
M
AKER