Product Maintenance - Fellowes POWERSHRED 90S Manual Del Usuario

BASIC SHREDDING OPERATION
PAPER OR CD/CARD
1
1
Continuous operation:
NOTE: Shredder runs briefly
after each pass to clear entry.
Plug in and put
Continuous operation beyond disconnect power
25-minutes will trigger
switch in ON (I) position
40-minute cool down period.

PRODUCT MAINTENANCE

CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1 2
Locate Auto-start
shredder
infared sensor
TROUBLESHOOTING
will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
continuous operation and recovery time for this shredder.
Remove Paper: When illuminated, press reverse (
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 5 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
usage standards, shredder operation using an improper power supply (other than listed on the
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
Australia Residents Only:
2 3
2
Feed paper straight into
Press ( ) ON to
paper entry and release
activate (blue)
.
3 4
4
Dip cotton swab in
rubbing alcohol away any contamination
from the paper sensors
additional costs incurred by Fellowes to provide parts or services outside of the country where the
more details or to obtain service under this warranty, please contact us or your dealer.
4 5
or
Hold CD/card at edge,
CD flap into place feed into CD/Card flap
entry and release
6
When finished
shredding set
to OFF ( )
the
3