Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the display (unless already installed)
Mounting the display is performed after hav-
ing inserted the majolica pieces (where pres-
ent) and is performed as follows:
1. Lightly unscrew the two central screws on
the rear of the stove in order to insert the
display (Pict. 19). Slide the display down
until it stops and then tighten the two
screws previously loosened.
2. Slide the whole length of the flat cable
through the appropriate channel on the rear
of the stove (Pict. 19 - A).
3. Connect the flat cable to the board dedi-
cated connector (Pict. 20).
Lighting
• Before lighting the stove, carefully read the
use and maintenance manual.
• Remove from the tank all the tools that were
inserted during packaging and be sure that
the tank is free of eventual extraneous
bodies.
• Unroll the environmental probe placed on
the rear of the stove, without placing it on
the heated parts of the stove.
• Correctly connect the pellet stove to the
flue.
• Fill the tank with 6mm diameter pellets.
• Open the door and check that the basket is
properly inserted in its slot and that the
flame trap is located in the upper part of the
combustion chamber.
• Close the door. Never open the door while
the pellet stove is operating.
• Connect the stove to an outlet with the
appropriate cable received with the stove.
• Place the switch on the rear of the stove at
the "1" position.
• Press the
key for 2 seconds and the
gearcase will begin its lighting cycle.
Pict. 19: fastening the display
Pict. 19: passing the flat cable
Pict. 20: fastening the flat cable to the board
10
Display
A
Channel for passing
the flat cable
A
PCB
B
Publicidad
