Setup & Installation - ThePondguy AquaStream AS05 El Manual Del Propietario

3. Setup & Installation
Fig. 1
Mooring Stake
Fig. 2
Loop
A. System Components in the Box:
1. Fountain Pump with Quick Disconnect, float mount ring and
Classic Spray Pattern (installed)
2. Float - Blue
3. Power Cord
4. Control Panel
5. Crown & Rocket Spray Pattern (interchangeable)
6. Geyser Spray Pattern (interchangeable)
B. Prepping the AquaStream™ for Installation:
1) Ensure you have power close to your pond. If you don't, we recommend to ALWAYS use a
licensed electrician to properly run power down to the pond.
2) Mount the Control Panel in a fixed position next to the power source.
3) Choose Your Spray Pattern (Fig. 3)
a) The AquaStream™ comes packaged with the Classic spray pattern installed. However,
the AquaStream™ includes two additional spray patterns (Geyser and Crown & Rocket).
Pick the one that best suits you or your special event.
b) To change a pattern, simply unscrew the nozzle nut, replace the pattern and reinstall the
nozzle nut.
4) Assembling the Unit (Fig. 4)
a) Lay the float flat on the ground with The Pond Guy
b) Place the fountain pump assembly into the center of the float.
c) Lift the float straight up and ensure that the fountain pump lead power cord passes
through the center hole. Gently lay the fountain to one side.
d) Securely attach the power cord to the fountain pump lead quick disconnect.
e) Attach the power cord strain relief to the loop underneath the float mount ring. (Fig. 2)
f) Attach a mooring cable (not included) for each of the two loops underneath the float
mount ring. (Fig. 2)
AquaStream™ Floating Fountain
Underwater Disconnect
Power Cord
Loop
logo facing up.
®
Mooring Line
(Vinyl Coated Galvanized Wire)
Carabiner
Recommended Mooring Kit
• 2 stakes
• 2 carabiners
• 4 cable clamps
• 150' or 250' black vinyl
coated galvanized cable
(Mooring Line)
Mooring Kit Options:
#651052 – 150' Mooring Kit
#651054 – 250' Mooring Kit
* Mooring Kit Not Included with Fountain
Fig. 3
Classic
Fig. 4
ENGLISH
Control
Panel
Crown & Rocket
Geyser
Unscrew Nozzle Nut to
change Patterns
TM
3A