Assembly; Assembling Sanding Table On Disc Sander; Assembling Sanding Table On Belt Sander - HOLZMANN MASCHINEN BT 150_914 Instrucciones De Servicio

 Hazard of injury or machine damage due to undetected machine defect
To minimize this risk, check the machine prior to every operation for loose screws and
connections. Damaged parts have to be replaced immediately, no operation of the machine
in the meantime!
 Hazard of electric shock
Undetected malfunctions in the power supply and/or the connected wood working machine
might result in electric shock when touching the machine. Ensure proper electric installation,
and let it check periodically by a trained electrician.
 Danger due to unintended machine start-up
Eliminate this risk by disconnecting the machine before you perform any checks or activities
on the machine.
 Hazard of inhaling toxic dust
Especially wood dust arising from chemically treated wood and/or lacquer/paint are harmful
when inhaled. Therefore wear a suitable breathing mask if required.
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge
and experience.
13

ASSEMBLY

Check right after receiving the machine, whether all parts according to the parts list are complete
and without damage. Each visible defect and in particular wrong amounts and transport damages
must be clearly noted on the delivery documents, otherwise the goods shall be considered as taken
over and fully accepted under the sole responsibility of the customer.
The sanding table can be used with both the sanding disc and the belt. It should be used to
support workpieces in all sanding operations except inside curve applications.

13.1.1 Assembling sanding table on disc sander

Place the Sanding table (1) onto the disc
sander frame, aligning the semi-circular
slot (2) with the threaded hole (3).
Place the washer (4) on the shaft of
worktable lock knob (5), insert through
semi-circular slot (2), and tighten into threaded hole (3)
Adjust sanding table to level or any angle
between 0° and 45° for sanding.
Attention! To prevent fingers from being squeezed
between the band and table a minimum
separation of 1.6 mm has to be maintained
between the table and sanding band.

13.1.2 Assembling Sanding table on belt sander

Loosen the inner hex screw (1) using the 5 mm hex
key, and raise the belt bed (2) in the 90 degree
vertical position. Tighten the inner hex screw (1).
Place the sanding table (3) onto the belt sander
frame, aligning the semi-circular slot (4) with the
threaded hole (5).
Place washer (6) on the shaft of sanding table lock
knob (7), insert through semi-circular slot (4), and
tighten into threaded hole (5).
Adjust worktable to level or any angle between 0°
and 45° for sanding
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
ASSEMBLY
23
BT150-914