Storage; Cleaning; Disposal; Trouble Shooting - HOLZMANN MASCHINEN BT 150_914 Instrucciones De Servicio

15.4

Storage

 Tension the sanding belt of the belt sander.
 Store the machine in a dry and well ventilated place.
15.5

Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
15.6

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
16

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine stops or will not start
Machine slows down during
working
Bad grinding results
To rapid wear of
Grinding angle is wrong
Sanding disc runs out of round
Sanding belt runs out of
sanding belt bed
Work piece burns during the
working process
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix
the problem.
HOLZMANN MASCHINEN GmbH
Possible cause
 ON/OFF-switch damaged
 Saw unplugged
 Overload tripped
 Fuse blown or circuit breaker
tripped
 Cord damaged
 Exerting too much pressure to
the sanding abrasive
 Abrasive too coarse-grained
 Abrasive too fine-grained
 Adjusted angle is wrong
 Sanding disc is eccentrically
mounted
 Sanding belt is mounted wrong
 Abrasive is dirty from oil
 Too much pressure
www.holzmann-maschinen.at
NOTICE
 Check the switch
 Check all power connections
 Allow motor to cool and reset
by pushing off switch
 Change fuse or reset circuit
breake
 Change cable
 Exert less pressure on the work
piece
 Use less coarsed abrasive
 Use more coarsed abrasive
 Readjust the angle
 Mount the sanding disc
centrally
 Mount the sanding belt
centrally
 Change abrasive
 Reduce pressure
NOTICE
TROUBLE SHOOTING
Solution
28
BT150-914