Technical Details; Limitations Of Use; Required Tools - Sortimo STS 2.0 LSL H1 Instrucciones De Uso

Technical details

Variable
Weight (empty)
Length
Width
Height

Limitations of use

Variable
Maximum payload
Installation
W A R N I N G
Risk of injury caused by incorrect torque
If the screw connections are not tightened to
the relevant torque levels, this may lead to
severe to fatal injuries in the event of heavy
braking or an accident.
▶ Comply with the stated torque levels.
This symbol indicates a
fastening for which a specific
torque must be observed.

Required tools

• Torque wrench 1-25 Nm,
• Battery-powered screwdriver,
• Drill Ø 8.0 mm,
• Hexagonal tool head A/F 10,
• Hexagonal socket tool head A/F 4,
• Metal cutting tool,
• Folding rule,
• Pencil.
© Sortimo International GmbH
Value
20 kg
min. 1860 mm
max. 3500 mm
1100 mm
410 mm
Value
35 kg
Prerequisites
- Vehicle is suitable for the installation.
- Vehicle is equipped with a Sortimo
TopSystem.
- Installation surfaces are free of dirt and
grease.
- Cross members are fitted end caps as
safety elements.
Note: There are four end caps in the scope
of delivery.
- Ends of the cross members are aligned to
each other. The ends are level.
Preparing for installation
1
1.1 Pre-assemble the telescopic bracket F.
▶ Remove the cable ties.
▶ Remove the screws.
▶ Position the tube E.
Note: There are two installation versions:
a Right side of the vehicle.
b Left side of the vehicle.
▶ Fasten the tube E.
▶ Tighten the screws.
▶ Fasten the hook A.
▶ Fasten the ladder limit stop C.
1.2 Pre-assemble the folding bracket G.
▶ Remove the cable ties.
▶ Remove the screws.
▶ Position the tube E.
Note: There are two installation versions:
a Right side of the vehicle.
b Left side of the vehicle.
▶ Fasten the tube E.
▶ Tighten the screws.
▶ Fasten the hook A.
1.3 Cut the tube D to the right length
▶ Define the position of the STS 2.0 Side
ladder lift.
▶ Measure the distance between the cross
members.
Note: The distance must be between 1380
mm and 3000 mm.
▶ Make a note of the distance: _____________
mm.
▶ If the distance is less than 2086 mm, cut
the tube to the following size:
Tube length = Distance - 500 mm
▶ Mark the middle of the tube with a pencil.
GA 00025 | 2018-12-19 | 1
English
9