Rear Panel Features; Power Switch - Numark ARC3 Manual De Inicio Rápido

11. PITCH – Activates the pitch slider and adjusts the amount of control the pitch slider has on the overall
speed of music. Tapping the pitch will toggle slider between 8% and 16% pitch ranges.
pitch for 3 seconds will deactivate the pitch control.
12. KEYLOCK – Engages and disengages the Keylock feature.
13. – /+ – Works as pitch bend and controls key and pitch functions.
14. PITCH SLIDER – Controls the overall speed of the music.
15. PITCH RANGE LED – Indicates current pitch range of the pitch slider
16. LOOP IN – Used to set stutter and loop in points.
17. LOOP OUT – Used to set loop out points and release the loop.
18. RELOOP/STUTTER – Used for repeated play (stutter) from the loop in point, repeating a previously
set, and hot start.
19. RELAY – Used for setting Alternating play start between attached units.
20. TAP – Tap this button with the beat of the music to determine the current Beats Per Minute (BPM).
This button also switches the mode of the display between showing the BPM and the percentage
change in pitch. To do this, hold the button for 1 second.
21. SCRATCH – Pressing once puts the jog wheel in Scratch Mode.
22. CD ILLUMINATION LIGHT (unit front) – lights up the CD drawer and CD when open.
23. CD DRAWER (unit front) – Place your CDs you wish to play in here. This unit is designed to play
commercially available CDs, mp3 CDs, and properly burned and finalized CD-Rs. Due to variances on
the specification of certain CD burners and CDs some discs home made CDs may not play properly.

REAR PANEL FEATURES

24. POWER SWITCH – Turn on and turn off the machine with this button. The unit should always be shut
down with this button first before any external power is removed. Typically, it is recommended that the
CD player is powered on before amplifiers and off after amplifiers to avoid an audio spike to be sent
through your equipment.
25. IEC CONNECTOR – Plug your supplied power cord in here.
26. VOLTAGE SELECTOR – Set this switch to the voltage for your location.
27. RCA CONNECTORS – Connect your CD player to your mixer from this line level output.
28. DIGITAL OUTPUT – The format is type 2, form 1, also known as S/PDIF (Sony/Phillips Digital Interface
Format).
29. RELAY CONNECTOR – If you wish to use the relay function plug in your 3.5mm stereo control cables
into here and then into your other unit.
properly
30. REMOTE START CONNECTOR – Use this connector to plug into your fader start compatible mixer or
remote switch. This function is always active.
supplied fader start cable to a fader start compatible mixer. Every time you move the crossfader on the
mixer over to the side that the unit is on, it will automatically start playing. When you move the fader
away from that side, the unit will stop. Moving the fader back to the unit side will start play again.
The cable must be a stereo style plug for the units to work
To use this connector for fader start, connect the
3
Holding the