Jay Focus Point Instrucciones Para El Uso página 5

J a y F o c u s P o i n t B a c k
®
SETTING THE HEIGHT OF THE BACKREST
Required tools: 7/16" wrench, tape measure
The Jay Focus Point Back must be mounted at the correct height on the backrest
tubes. Sunrise Medical recommends that the initial fitting and positioning of the back-
rest take place under the supervision of a clinician, or a rehab technology supplier. The
height of the backrest is adjusted by loosening the screws that secure the drop pin
clamp and the bottom hook clamp.
1. Establish the height of the backrest by loosening
the screws (Fig. 4-E) that secure the bottom hook
clamps. Raise or lower the clamps and retighten,
checking that the backrest pan is at the proper
height when the hooks are installed into the
clamp hook cradle. Make certain that the left and
right hardware is installed at the same height by
measuring the height of each clamp.
2. Tighten the screws securing the bottom clamps
firmly.
3. Determine the correct height of the drop pin clamps. Slide the pin in the
receiver to the unlocked (raised) position. Slide the upper clamp hardware on
the backrest tubes so that they reside just above the top hooks when the hooks
cradle the backrest tubes. Allow for a small 1/16" (2mm) clearance between
the top hooks and the drop pin clamps/quick release bracket hardware.
4. Tighten the screws firmly.
CHANGING THE HEIGHT POSITION OF THE FOCUS POINT BACK
Required tools: 7/16" wrench
It is possible to change the height position of the back
on the wheelchair without changing the position of the
clamps. Such adjustment is needed when either of these
parts is located in a position that interferes with other
components mounted to the backrest tube.
1. Remove the back foam from the backrest pan.
2. If the width of the hinge plate has already been
established (see instructions for width adjust-
ment), mark their location using a pencil. This
will assist in maintaining the correct width position when the brackets are
moved to a different height.
3. Loosen and remove the nuts and washers (Fig. 3-A) securing the hingeplate
and remove the backrest pan from the bracket.
E
A
5
4
5
B
100823 Rev. A