Publicidad
Step 15
Carefully turn your unit over onto its back.
å
Before fastening the DOOR to your unit, be sure the mounting screw
å
is against the stops as shown in the diagram. If it isn't, loosen the
mounting screw to slide it against the stops. Then tighten the
mounting screw.
Fasten the LEFT DOOR (L) to the TOP (G2). Use the screws in the
å
HINGES. See the next step for adjustments.
Fasten the DOOR STAY (S) to the DOOR (L) and UPRIGHT (E). Use
å
four BLACK 9/16" LARGE HEAD SCREWS (GG).
NOTE: When the DOORS are opened all the way, the DOOR STAY will
å
keep the DOOR from falling shut. To close the DOOR, lift up on the
DOOR STAY arm while holding the DOOR with your other hand. This
will "unlock" the DOOR STAY. Do not force the DOORS shut.
Peel the FELT DISC from the FELT DISC CARD (AA). Stick a FELT DISC
å
on the DOOR where it comes in contact with the UPPER SHELF (H).
Repeat this step for the RIGHT DOOR (K).
å
AA
www.sauder.com/services
AA
S
L
E
G2
H
Hinge
BLACK 9/16" LARGE HEAD SCREW
408292
Mounting
screw
Stop
GG
(8 used for the DOOR STAYS)
Page 19
Publicidad
