Periodic Maintenance; Troubleshooting; Spare Parts; Disposal - PLYMOVENT FLEXHOOD Instrucciones Para El Uso

6 MAINTENANCE
The product has been designed to function without problems for
extended periods with minimum maintenance. In order to
guarantee optimal performance level, regular maintenance and
cleaning activities are required which are described in this
chapter. If you observe the necessary caution and carry out the
maintenance at regular intervals, any problems occuring will be
detected and corrected before they lead to a total breakdown.
The indicated maintenance intervals can vary depending on the
specific working and ambient conditions. Therefore it is
recommended to thoroughly inspect the complete product once
every year in addition to the indicated periodic maintenance. For
this purpose contact your supplier.
WARNING
Overdue maintenance can cause fire.
6.1

Periodic maintenance

The maintenance activities in the table below indicated by (
can be carried out by the user; other activities are strictly
Component
Main frame profiles, roof panels
Lighting fixture
Automatic damper (if any)
Bottom roof panels and extraction
slots
Top roof panels
1. Contact your supplier to determine intensity of use.
7

TROUBLESHOOTING

If the modular hood does not function (correctly), follow
cleaning procedure as described under section 6.1. If the
problem still exists, contact your supplier.
8

SPARE PARTS

The following spare parts are available for the modular hood:
Article no. Description
9750000050 Distance holder (10 pcs)
9750000060 Vertical spacer (10 pcs)
9

DISPOSAL

After life of the product, dispose it of in accordance with state or
local regulations.
0508040020/010111/D FlexHood
1
)
Action
Check outside of the hood and clean it with a non-
aggressive detergent.
Check working light.
Check functionality of the connected automatic damper.
Check the bottom roof panels and extraction slots of the
hood and clean them thoroughly.
Clean the inside of the hood and slots by removing top roof
panels.
reserved for well trained and authorised service engineers.
ATTENTION!
Always wear face mask and gloves during service and
maintenance work.
Industrial vacuum cleaner used during service and
maintenance should meet dust class H according to
the European standard EN 60335-2-69 or equivalent
international standard.
ATTENTION!
Always wear a respirator and gloves during service
and maintenance work.
Industrial vacuum cleaner used during service and
maintenance should have HEPA rated filtration.
WARNING!
Never stand on top of the
extraction hood.
1)
Light use : Every 3-6 month Every 12 month
1)
Normal use : Every 3 months Every 9 months
1)
Heavy use : Every 1-2
months
X (
X (
X (
X (
Frequency
Every 6 months
1
)
1
)
X
1
)
X
1
)
X
EN - 11