Assembling And Installing; Installation; How To Open The Housing; How To Install The Camera - Avigilon ES-HD-HWS Manual De Instrucciones

6 Assembling and installing

The assembly and installation must be
performed only by skilled personnel.

6.1 Installation

6.1.1 How to open the housing

For the ES-HD-HWS or ES HD-CWS, loosen the 2
screws on the side, turn the cover and the upper
half of the body about the opening hinge axis.
Fig. 1 ES-HD-HWS and ES-HD-CWS only
For the ES-HD-HWS-LG and ES-HD-CWS-LG,
Loosen the 4 screws on the base of the enclosure
and lift the housing off the base.
1
Fig. 2 ES-HD-HWS-LG and ES-HD-CWS-LG only
6

6.1.2 How to install the camera

Power supply can be provided by the
board supplied with the product. Make
sure the voltage values are appropriate.
Open the housing as described previously (6.1.1
How to open the housing, page 6).
Extract the internal support slide by partially
loosening the fastening screws (01).
Move the slide, by sliding it until the holes coincide
with the slide locking screws (02).
Fasten the camera with the 1/4" screw. If necessary,
use the supplied spacers to correctly position the
camera and optics (03).
01
Fig. 3
Reposition the internal slide by tightening the
previously loosened screws.
Remove the conductors protective sheathing
2
and connect them to terminal (J5, 6.1.3 Board
description, page 7).
The camera's power supply cable conductors must
be tied up with a cable tie next to the terminal.
Keep the signalling and power supply cables
separated from each other.
Tip: Turning the slide upside down will increase
the vertical space available and is required to
support certain camera and lens combinations.
ES-HD-HWS/ES-HD-CWS/ES-HD-HWS-LG/ES-HD-CWS-LG
03
02