Draining The Tank; Checking The Safety Valve - GreenWorks Tools 4101302 Manual De Utilización

GB
FR DE ES
1. Ensure auto/off switch is in the off position (O) and the
air compressor is unplugged.
2. Confirm that the outlet pressure is at zero bar by fully
turning the regulator knob counterclockwise to fully
reduce air pressure at the outlet.
NOTE: Turning the knob clockwise increases air
pressure at the outlet. Turning counterclockwise
reduces air pressure at the outlet.
3. Attach coiled air hose to coupler on the side of the air
compressor.
4. Connect the air compressor to a power supply and turn
power switch to the auto position (I).
5. Allow unit to reach max pressure as indicated on the
tank pressure gauge.
6. Set regulator to desired pressure by rotating pressure
regulator knob. The regulator pressure will appear on
the gauge marked as outlet.
To disconnect a coiled air hose:
1. Confirm that the outlet pressure is at zero bar.
2. When disconnecting a hose from 6.4 mm quick coupler,
always firmly hold release end of hose.
3. Pull back on the release sleeve on the 6.4 mm quick
coupler.
4. With a firm grip, pull out the quick-connect air fitting
that is attached to the quick coupler.
5. Attaching or disconnecting pneumatic tools from the
air compressor.
NOTE: Each tool is different. Refer to the instructions of
the manufacturer before operating a tool in the seated
position.
Risk of bursting. Do not adjust regulator to result in
output pressure greater than marked maximum pressure
of attachment and/or the item being inflated. Never use
at pressure greater than 6.9 bar. Failure to heed this
could result in possible serious personal injury.
Air powered tools may require more air consumption
than this air compressor is capable of providing. Check the
tool
manual to avoid damage to the tool or risk of personal injury.
IT NL PT DA SV
WARNING
WARNING
FI NO RU PL CS
English
1. Connecting hoses to the air compressor.
2. Control the amount of air flow with the pressure
regulator knob.
NOTE: Always use the minimum amount of pressure
necessary for your application. Using a higher
pressure than needed will drain air from the tank more
rapidly and cause the unit to cycle on more frequently.
3. When finished, always drain the tank and unplug the
unit. Never leave the unit plugged in and/or running
unattended.

DRAINING THE TANK

1. To help prevent tank corrosion and keep moisture out
of the air used, the air tank of the compressor should be
drained daily.
2. Turn the air compressor off.
3. Pull the ring on the safety valve to release until
pressure gauge reads less than 1.4 bar.
4. Release the ring.
5. Rotate drain valves counterclockwise to open.
6. Tilt tank to drain moisture from tank into a suitable
container.
NOTE: Condensate is a polluting material and should
be disposed of in compliance with local regulations.
7. If drain valve is clogged, release all air pressure,
remove and clean valve, then reinstall.
Unplug the air compressor and release all air from the
tank before servicing. Failure to depressurize tank before
attempting to remove valve can cause serious personal
injury.
8. Rotate drain valve clockwise until tightly closed.

CHECKING THE SAFETY VALVE

Do not attempt to tamper with the safety valve. Anything
loosened from this device could fly up and hit you.
Failure to heed this could result in death or serious
personal injury.
6
HU RO LV LT ET
WARNING
DANGER
HR SL SK BG